1, USES:

glass washing machine CP-2500A used for cleaning and drying the upper and lower surfaces of ordinary plate glass and high quality low-e glass,it is composed of incoming segment, cleaning air-drying segment and outgoing segment.

2, Structural characteristics:

1.Aluminum alloy assembly structure, no scrap concept, permanent use,
High efficiency, energy saving 70% efficiency;

2. The remaining sheet metal parts are all made of advanced mechanical spraying

Paint or powder;

3. The rubber roller adopts vulcanized rubber and stainless steel shaft;

4. The washing part in contact with water is made of stainless steel;

5. In the cleaning department, the wind staff lifts up and down as a whole, the maximum lift is 350mm, which is convenient for cleaning and maintenance;

6. Three pairs of brushes (Ø150mm) stainless steel shaft configuration (Low-E glass, ordinary coated glass, daylight coated glass can be washed without damaging the coated surface);

7. Two pairs of special stainless steel aluminum alloy air knife configuration, strong wind, good drying effect, with the heating system (with a temperature control device, opening and closing optional);

8. The fan is equipped with an air filter in the air inlet room, which has a large air volume and a good air-drying effect. The entire wind box is installed in the upper part of the workshop, with an air filter on the side for easy inspection and cleaning;

9. The main drive gear is driven by frequency conversion and digital display. The rotation of the brush roller in the washing section is driven by independent belts of the upper and lower motors. The frequency conversion speed regulation is stable, and the service life is long, which can realize the cleaning of high-demand special glass;

10. Mechanical button control, washing machine digital display, simple operation, simple operation, and convenient maintenance;

11. The water tank of the washing machine is installed outside, which is convenient for cleaning, replacing, and checking the water tank, making the washing effect of the washing machine cleaner.

12. PLC control and touch screen display are optional, which is convenient for workers to operate and maintain and can be connected with edge grinding machines of various manufacturers without gaps. (Need to be purchased separately)

3, Technical parameters:

1. Maximum glass width: 2500mm (effective maximum: 2650mm)

2. Minimum glass specification: 400mm×400mm (limited to left and right single row)

3. Glass thickness: 3mm-25mm (digital display)

4. Speed range: glass thickness is 3-25mm Vmax=1-12m/min

5. Main drive and electric brush speed regulation mode: frequency conversion speed regulation

6. Workbench height: 900±25mm

7. Total power: 42KW (Hydraulic wind-heat: 15KW)

8. Water source: self-circulation, tap water (according to civil water standards), and deionized water supplement (deionized water equipment needs to be provided by the buyer)

9. Power supply: 380V 50Hz

10. Dimensions (length×width×height): about 6260×4800×3100

11. Weight: about 3940kg